Форум ЛаминатPro-Remont.com Forum Laminat
Forum Laminate (communications-10)
Topic : Laminat Hello! Need tips on laminate flooring. And of floor. 1. Do plate? 2. On my floor were only ldagi. The most lags, it is screwed to a cement slab? 3. I know that lags should fall plywood. What plywood choose?
Subject : Re : Laminat You can not use lags (skripet they are likely) 1. Irregularities and variations of more than 2 mm / m, should be eliminated. 2. To address more serious defects using samovyravnivayuschie mixture or concrete plate. By the time the work on laying laminate residual moisture cement floor must not exceed 2.5%. 3. At the plate became resistant plywood sheets (> 10 mm), about the size of meter to meter. Between sheets of plywood binding ranges (0.5 cm). Plywood plant on the dowels. The surface B. flat. Cap should never laugh. But if you do not want plywood, it is not put (the issue rather religious). 4. Before laying laminated coating on the ground should pre nastelit waterproofing plastic film thickness of 200 microns, which joints secured by adhesive tape. If waterproof coating (PVC linoleum, etc.) laminate can be constructed without a plastic substrate. 5. It lay plastic sheeting over plywood or other organic floor coverings (wood, chipboard, MDF, etc.). 6. In addition to hydrolyzing films, and only in such cases, in order to improve the performance of the laminated floors, the special-regulation. Accomplished from polyethylene foam, it provides a good thermal and acoustic insulation. If the substrate is made from specially impregnated and evenly spressovannyh wood fibers, it offers maximum absorption contact noise (when and plywood is not required, in fact). 7. In terms of the aesthetic field will look best if your plank parallel incident rays of light. The narrow space look so much more attractive when the panels are laid along the lake. If laminated cover fits over the existing wooden boardwalk, the panel must be perpendicular to the old floor boards. 8. Start installation of laminated panels can be from any corner of the room and continue installation work in the right direction, which is very convenient. Installation should be made with the temperature of 15-20 degrees and a relative humidity of 50-60%. The newly acquired laminate be conditioned packaged within 48 hours. 9. As the temperature and humidity space with the passage of time may vary, for example, depending on the season, have to be able to expand in all directions. This expansion is usually about 2 mm per linear metre boardwalk. Therefore, the higher surface area zastilaemoy, the greater would be expanded. The perimeter walls and around pipes shall be provided for temperature measuring 8-10 mm gap. In the field of doors, the two facilities at the border when the device porozhkov provided, as well as to cover large areas (more 8h12 m), among floor sites must leave strain seam (not less than 8 mm), special subsequently closed extensive profiles.
Subject : Re [2] : Laminat Thank you very much for a clear explanation. Now, another question arose, primarily done? 1.Ustanavlivaetsya door or stored floors? (laminate)
Subject : Re [3] : Laminat The door will include installation of the box? If so, it (box) must be used to laying laminate. Remember only about termoshvy. The doors are to be installed when the surface.
Subject : Re [4] : Laminat I unfortunately do not give any advice I can. I have a question here instead. Can anyone tell me about laminate? I heard that there is great weakness mol often floors washed two times a day, laminate collects dust very well. True or not?
Subject : Re [5] : Laminat Many write that lags be set in two layers of plywood? ? ? Why so many? Why not do one layer of plywood?
Subject : Re [6] : Laminat Care laminate. Attach fetrovye base to the legs of tables, chairs and other mebe-li; Wheels on the chairs and furniture effort should be "soft" type. Heavy furniture should be raised, and not pull to cover. Laminate is not collecting dust. The daily care field dos-tatochno propylesosit well depressed or wipe with a cloth with water vapour in dobavleni-em drops of vinegar. Slow pollution also can be cleared by the well-worn clothing depressed. To remove a stronger pollution, use detergent designed for this type of floor covering. Once wipe the floor damp cloth. To avoid damage to never use abrasive cleaners, as well as tools, not re-komendovannymi po-kryty producer. Never a cleaning coating using large quantities of water. Immediately remove the spilled liquid on the floor.
Subject : Re [7] : Laminat Zlata, thanks for the reply! It turns out that not all of the words to believe.
Subject : Re [8] : Laminat Why leave the interfaces plywood ranges of 5 mm.
Subject : Re [9] : Laminat > Why keep the interfaces plywood ranges of 5 mm. To avoid the problems associated with the deformation-heat, humidity changes due to age and the like.
|
